HearthStone Quality Home Heating Products Inc

Champlain Model #8300

OWNERS INFORMATION

The installation must conform with local codes or, in the absences of local codes, the current National Fuel Gas Code, ANSI Z223.1 (NFPA 54) or CAN/CGA B149 Installation Code. (Installer l’appareil selon les codes ou règlements locaux, ou, en l’absence de tels règlements, selon les Codes d’installation CAN/CGA-B149.)Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the heater and to replace any part of the control system and gas control that has been under water. (Ne pas se servir de cet appareil s’il a été plongé dans l’eau, complètement ou en partie. Appeler un technicien qualifié pour inspector l’appareil et remplacer toute partie du système de contrôle et toute commande qui ont été plongés dans l’lau.

LIGHTING INSTRUCTIONS

NOTE: The gas control knobs and the piezo ignitor are located behind the control valve access door, under the front of the unit.

1.STOP! Read the What To Do If You Smell Gas! Warning (on the cover of this manual).

2.Set the on/off/T-stat switch or thermostat to the “OFF” position.

3.Push in and turn gas control knob clockwise to “OFF”. (If not previously lit, the knob should be in this position.)

4.Wait (5) five minutes to clear out any gas. If you then smell gas, STOP! Smell all around the appliance area for gas. Be sure to smell next to the floor because some gases are heavier than air and will settle on the floor. If you smell gas immediately follow the What To Do If You Smell Gas! warning on the cover of this Manual. If you do not smell gas, proceed to the next step.

5.Turn gas control knob counter-clockwise to “PILOT”.

6.Push in control knob all the way and hold in. Immediately light the pilot with the gas lighter (push in and “click” the piezoelectric spark ignitor button several times until lit). Continue to hold the control knob in for about 20 seconds after the pilot is lit. Release the knob and it will pop back out. Pilot should remain lit. If the pilot goes out, repeat the operation.

If knob does not pop out when released, stop, shut off the gas supply to the heater and immediately call a qualified service technician or gas supplier.

If the pilot will not stay lit after several tries, turn the gas control knob “OFF” and call a qualified service technician or gas supplier.

7.After the pilot lights, turn gas control knob counter-clockwise to “ON”.

8.If the ON/OFF/THERMOSTAT switch is set to “ON”, the stove should now be lit. If the thermostat (or remote) has been

installed, set the ON/OFF

THERMOSTAT switch to

“THERMOSTAT” and turn the thermostat (or remote) to “ON”. Then set the desired temperature.

9.Shut the gas control valve access door.

NOTE: When pressing/clicking the piezoelectric spark ignition button to light the pilot, watch through the glass (front) of the unit. Click the ignitor button until a flame is visible at the pilot. Once the pilot is lit, continue to press on the gas control knob for another 20 seconds, then release. Ascertain that the pilot is still lit by looking through the front door. If lit, then turn the gas control knob fully counter-clockwise to

8

Page 8
Image 8
Hearth and Home Technologies 8300 owner manual OWNER’S Information, Lighting Instructions