Hearth and Home Technologies 8300 owner manual To Turn OFF GAS to Appliance, Daily Operation

HearthStone Quality Home Heating Products Inc Champlain Model #8300

the “ON” position. If the pilot fails to light, or if it went out due to a premature release of the gas control knob while pressed in the “PILOT” position, wait 60 seconds for the Interlock to release. Then repeat the lighting process as described in this section of the manual.

Once the pilot has been lit, the gas control knob has been turned to the “ON” position, and the ON/OFF/T-STAT switch has been turned to “ON”, the main burners should light immediately. If you would like to use the thermostat and it has been installed, switch the ON/OFF/T-STAT switch to thermostat. Turn the thermostat to "ON" and set it to a higher position so that it "calls" for heat in order to turn light the main burners (i.e. turns the unit on). Note that the thermostat controls the on/off cycling of the main burners, but the pilot remains lit regardless of the thermostat setting. The only way to turn the pilot off is to turn the gas control knob fully clockwise to the “OFF” position.

TO TURN OFF GAS TO APPLIANCE

1.Set the thermostat to the “OFF” position or turn the ON/OFF/T- STAT switch to the “OFF” position.

2.If shutting the unit off for the non- heating season, turn the gas control knob fully clockwise to the “OFF” position. Do not force the knob to turn.

DAILY OPERATION

The Champlain gas-fired heater is easily operated by the homeowner once installed and adjusted by a qualified service technician. Following is a list of the controls available to the owner/user:

A. ON/OFF/PILOT………Built into Valve

B.VARIABLE OUTPUT CONTROL……………Built into Valve

C.ON/OFF/THERMOSTAT

SWITCH…………………...…Standard

D.THERMOSTAT………………Standard

E.REMOTE CONTROL (w/o thermostat)…………………....Optional

F.REMOTE CONTROL

(w/thermostat)…………….…..Optional

G.BLOWER……………………..Optional

A.ON/OFF/PILOT

The valve is equipped with two “control knobs”. One is the ON/OFF/PILOT knob, located on the front left side of the valve. When in the “OFF” position, the unit cannot operate at all. When in the “PILOT” position, the pilot light can be lit, but that is all. When in the “ON” position, the unit may be on continuously, or it may be “waiting” to be controlled by the thermostat or remote, depending on the setting of the other controls.

B.VARIABLE OUTPUT CONTROL

The Variable Output Control knob, located on the front right side of the valve, controls the “rate” heat is produced. By adjusting the variable output control the rate of heat output can be varied to meet the heating requirements of the season. Choosing a “LOW” flame setting will result in longer burn cycles at a reduced output, while choosing a “HIGH” flame setting will result in a shorter, hotter burn cycle. Through trial and error you can select the optimum flame size for you setting and application.

C.ON/OFF/T-STAT SWITCH

The ON/OFF/T-STAT switch controls how the unit will operate, continuously or by thermostat. When the switch is in the “ON” position, the main burner

9