Hearth and Home Technologies 8300 owner manual Venting KIT KIT #93-65000

HearthStone Quality Home Heating Products Inc Champlain Model #8300

INSTALLATION INSTRUCTIONS

FOR THE STANDARD HORIZONTAL

TERMINATION MINIMUM

VENTING KIT (KIT #93-65000)

1. Install the 4” inner collar by first			› Caution: For				building with vinyl siding,
	placing the 4” x 6” gasket ring onto		a vinyl siding standoff should be installed
	the base of the collar. Install the		between the vent cap and the exterior
	collar and gasket to the stove using 8		wall.
	of the screws provided.		7.	Install			the	horizontal		vent
2.	Install	the outer collar in similar		termination on the outside of						the
	fashion using the larger gasket ring			wall. Make sure both of the retaining
	and the remaining 8 screws.			straps extend through interior wall
				thimble.		Before		attaching	the	vent
3.	Install	the 45º elbow over the outer		termination to the outside of the
	collar. Place the elbow so that the			house, run a bead of non-hardening
	twist lock end is pointing up.			mastic around its’ outside edges, so
				as to make a seal between it and the
4.	Install	one of the 24” pipe sections		wall. The arrow on the end cap
	into the elbow by fully inserting it			should point up. Secure the cap to
	and turning approximately ¼ turn			the wall with the appropriate screws.
	clockwise, until the 2 sections are
	fully locked. Install the 90º elbow in		8.	Place the thimble cover onto the 90º
	similar fashion.			elbow. Put the 9” pipe into the
				horizontal vent cap, (the vent pipe
5.	Move	the stove and pipe assembly		must extend into the horizontal vent
	back until the 90º elbow is flush to			cap a minimum of 1-1/4”). Move the
	the wall. The 24” vertical pipe			stove and vent pipe into position,
	should be parallel to the wall. Draw a			insert the 9” pipe into the 90º elbow
	circle around the pipe. Use the center			and twist to lock it. Secure the straps
	of this	circle as the center point of		from	the	horizontal vent			termination
	the 10” x 10” square wall pass			to the interior pipe with 2 sheet metal
	through. (It should be approximately			screws, keeping screws close to wall
	55” above the floor) Cut and frame			thimble as possible. Bend or cut the
	the wall pass through.			excess strapping so that the thimble
				cover	will		fit	properly.	Screw	the

6. Place	the	interior	wall	thimble	into	thimble cover to the wall.
the 10” x 10” wall pass through.
Secure	it	with	4	screws	(not

provided). Install the exterior portion of the thimble in similar fashion, overlapping the 2 sections.

23