HearthStone Quality Home Heating Products Inc | Champlain Model #8300 |
INTRODUCTION | 3 |
SAFETY INFORMATION | 4 |
FIRE HAZARD | 5 |
SHOCK HAZARD | 5 |
MUST BE VENTED TO THE OUTSIDE | 5 |
SERVICE CAUTION | 5 |
HOT SURFACES | 5 |
CERAMIC FIBER LOG SAFETY |
|
INFORMATION | 6 |
SPECIFICATIONS: | 7 |
OWNER’S INFORMATION | 8 |
ROUTINE MAINTENANCEAND CARE | 10 |
FIREBOX, PILOT, & BURNER TUBES | 11 |
INSTALLER’S INFORMATION | 11 |
UNPACK AND INSPECT FOR DAMAGE | 12 |
VENTING INFORMATION | 16 |
ELECTRICAL CONNECTIONS | 24 |
GAS SUPPLY & CONNECTIONS | 27 |
LOG PLACEMENT | 28 |
LIGHTING THE UNIT FOR THE FIRST TIME |
|
................................................................... | 31 |
INITIAL ADJUSTMENTS | 32 |
MAINTENANCE AND CARE | 34 |
PARTS LISTS | 36 |
SAFETY INFORMATION
Your Champlain is a very attractive and extremely efficient, utilizing today’s best technologies. By following a few simple safety precautions and by performing minimal maintenance, the unit will remain appealing while providing years of quality performance.
The installation must conform to local codes or, in the absences of local codes, the current National Fuel Gas Code, ANSI Z223.1 (NFPA
54)or CAN/CGA B149 Installation Code. (Installer l’appareil selon les codes ou réglements locaux, ou, en l’absence de tells réglements, selon les Codes d’installation CAN/CGA B149.)
Do not use this appliance if any part has been
›WARNING:
A qualified service technician should do
installation and repair. A qualified service technician should inspect the appliance before use and at least annually. More frequent cleaning may be required due to excessive lint from carpeting, bedding material, etc. It is imperative that control compartments, burners, and circulating air passages of the appliance are kept clean and free of obstructions. (S’assurer que le brûleur et le compartiment des commandes sont
propres. Voir les instructions
d’installation et d’utilisation qui accompagnent l’appareil.)
under water. Immediately call a qualified service technician to inspect the heater and to replace any part of the control system and gas control that has been under water. (Ne pas se servir de cet appareil s’il a été plongé dans l’eau, complétement ou en partie. Appeler un technicien qualifié pour inspector l’appareil et remplacer toute partie du systéme de contrôle et toute commande qui ont été plunges dans l’lau.)
During the first few hours of operation the appliance may produce a slight smoke and/or odor. This is normal during the first several burns. During the initial burn, open a window(s) to assist in the removal of the smoke/odor. If the logs appear to smoke, turn the heater off and call a qualified service technician.
The appliance and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of
4
