Hearth and Home Technologies SOHO-CE 7

Heat & Glo • Soho-CE • 2111-900 Rev. D • 6/07 17

7 Appliance Preparation

NAILING TABS

111.8 cm

A. Securing and Leveling the Appliance

The diagram shows how to properly position, level, and se-

cure the appliance (see Figure 7.7). Nailing tabs are pro-

vided to secure the appliance to the framing members.

• Place the appliance into position.

• Level the appliance from side to side and front to back.

• Shim the appliance, as necessary. It is acceptable to use

wood shims.

• Bend out nailing tabs on each side.

• Keep nailing tabs ﬂ ush with the framing.

• Secure the appliance to the framing by using nails or

screws through the nailing tabs.

Figure 7.7 Proper Positioning, Leveling and

Securing of a Appliance

Fire Risk.

• ALWAYS maintain speciﬁ ed

clearances around the appliance.

• Do NOT notch into the framing around the appliance spacers.

Failure to keep insulation, framing or other material away from

the appliance may cause ﬁ re.

WARNING

Contents

Main Model: Soho-CE Installers Guide 0063-06 Congratulations Homeowner Reference Information Table of Contents 1 B. Non-Combustible Materials Speci cation C. Combustible Materials Speci cation A. Appliance Certi cation 2 A. Design and Installation Considerations 2 C. Inspect Appliance and Components B. Tools and Supplies Needed 3 A. Selecting Appliance Location NOTE: For actual appliance dimensions refer to Sec- tion 16. B. Constructing the Appliance Chase C. Clearances 4 A. Flue Termination Minimum Clearances A * 91 cm minimum in snow regions (See Figure 4.4 for speci c clearances) 4 Measure vertical clearances from this surface. Figure 4.2 speci es minimum ue heights for various pitched roofs. V = VENT TERMINAL X Alcove Applications 5 Horizontal B. Use of Elbows A. Flue Table Key C. Measuring Standards 1. Horizontal Termination One Elbow Two Elbows V H D. Flue Diagrams 1. Horizontal Termination - (continued) Three Elbows H V H V 2. Vertical Termination No Elbow Two Elbows V1 = 11.8 m Maximum V 2. Vertical Termination - (continued) Three Elbows V H V INSTALLED HORIZONTALLY H 6 B. Wall Penetration Framing A. Pipe Clearances to Combustibles C. Vertical Penetration Framing 7 A. Securing and Leveling the Appliance 8 8 A. Assembly of Flue Sections B. Installing Firestops and Horizontal Termination Cap * 91 cm minimum in snow regions C. Install Roof Flashing and Vertical Termination Cap Page 9 A. Gas Pressure Requirements 9 B. Gas Connection 10 Heat & Glo Soho-CE 2111-900 Rev. D 6/07 23 A. Electronic Ignition System Wiring Figure 10.1 Electronic Ignition Wiring Diagram 11 11 A. Facing Material B. Mantel Projections 12 12 A. Remove Shipping Materials B. Clean the Appliance Page F. Glass Assembly 13 A. Before Lighting Appliance 13 B. Lighting the Fireplace LIGHTING INSTRUCTIONS CAUTION: WARNING: NOT FOR USE WITH SOLID FUEL C. After Appliance is Lit D. Frequently Asked Questions 14 14 A. Electronic Ignition System 15 15 A. Maintenance Tasks Inspect Maintenance Tasks 16 Appliance Dimensions Table 16 A. Appliance Dimension Diagram SOHO-CE B. Service Parts List SOHO-CE Service Parts SOHO-CE C. Limited Lifetime Warranty LIMITED LIFETIME WARRANTY HEAT & GLO GAS APPLIANCE PRODUCTS