Hearth and Home Technologies SOHO-CE 2 , 2

Heat & Glo • Soho-CE • 2111-900 Rev. D • 6/07 5

A. Design and Installation Considerations

Heat & Glo balanced ﬂ ue gas appliances are designed

to operate with all combustion air siphoned from outside

of the building and all exhaust gases expelled to the out-

side. No additional outside air source is required.

2 Getting Started

C. Inspect Appliance and Components

When planning an appliance installation, it’s necessary to

determine the following information before installing:

• Where the appliance is to be installed.

• The ﬂ ue system conﬁ guration to be used.

• Gas supply piping.

• Framing and ﬁ nishing details.

B. Tools and Supplies Needed

Before beginning the installation be sure that the following

tools and building supplies are available.

Reciprocating saw Framing material

Pliers Hi temp caulking material

Hammer Gloves

Phillips screwdriver Framing square

Flat blade screwdriver Electric drill and bits (1/4 in.)

Plumb line Safety glasses

Level Manometer

Tape measure Voltmeter

Noncorrosive leak check solution

One 1/4 inch female connection (for optional fan).

1/2 - 3/4 inch length, #6 or #8 Self-drilling screws

• Carefully remove the appliance and components from

the packaging.

• The ﬂ ue system components and trim doors are shipped

in separate packages.

• The logs are packaged separately inside the ﬁ replace

and must be ﬁ eld installed.

• Report to your dealer any parts damaged in shipment,

particularly the condition of the glass.

• Read all of the instructions before starting the insta-

llation. Follow these instructions carefully during the

installation to ensure maximum safety and beneﬁ t.

Check building codes prior to installation.

• Installation MUST comply with local, regional, state and

national codes and regulations.

• Consult local building, ﬁ re ofﬁ cials or authorities having jurisdic-

tion about restrictions, installation inspection, and permits.

CAUTION

Inspect appliance and components for damage.

Damaged parts may impair safe operation.

• Do NOT install damaged components.

• Do NOT install incomplete components.

• Do NOT install substitute components.

Report damaged parts to dealer.

Hearth & Home Technologies disclaims any

responsibility for, and the warranty will be voided

by, the following actions:

• Installation and use of any damaged appliance or ﬂ ue

system component.

• Modiﬁ cation of the appliance or ﬂ ue system.

• Installation other than as instructed by Hearth & Home

Technologies.

• Improper positioning of the gas logs or the glass door.

• Installation and/or use of any component part not approved

by Hearth & Home Technologies.

Any such action may cause a ﬁ re hazard.

WARNING