Hearth and Home Technologies SOHO-CE 3

Heat & Glo • Soho-CE • 2111-900 Rev. D • 6/07

1.3 cm

ALCOVE

INSTALLATION

TOP VENT,

ONE 90º ELBOW

MINIMUM

Figure 3.1 Appliance Locations

ABCD

Centimeters 84.1 74.0 118.7 89.2

In addition to these framing dimensions, also reference the following sections:

• Clearances and Mantel Projections (Sections 3.C and 11.B).

• Flue Clearances and Framing (Section 6).

3 Framing and Clearances

Note:

• Illustrations reflect typical installations and are FOR

DESIGN PURPOSES ONLY.

• Illustrations/diagrams are not drawn to scale.

• Actual installation may vary due to individual design

preference.

Fire Risk

Provide adequate clearance:

• Around air openings

• To combustibles

• For service access

Locate appliance away from trafﬁ c areas.

A. Selecting Appliance Location

When selecting a location for your appliance it is important

to consider the required clearances to walls (see Figure

3.1).

NOTE: For actual appliance dimensions refer to Sec-

tion 16.

WARNING

Contents

Main Model: Soho-CE Installers Guide 0063-06 Congratulations Homeowner Reference Information Table of Contents 1 B. Non-Combustible Materials Speci cation C. Combustible Materials Speci cation A. Appliance Certi cation 2 A. Design and Installation Considerations 2 C. Inspect Appliance and Components B. Tools and Supplies Needed 3 A. Selecting Appliance Location NOTE: For actual appliance dimensions refer to Sec- tion 16. B. Constructing the Appliance Chase C. Clearances 4 A. Flue Termination Minimum Clearances A * 91 cm minimum in snow regions (See Figure 4.4 for speci c clearances) 4 Measure vertical clearances from this surface. Figure 4.2 speci es minimum ue heights for various pitched roofs. V = VENT TERMINAL X Alcove Applications 5 Horizontal B. Use of Elbows A. Flue Table Key C. Measuring Standards 1. Horizontal Termination One Elbow Two Elbows V H D. Flue Diagrams 1. Horizontal Termination - (continued) Three Elbows H V H V 2. Vertical Termination No Elbow Two Elbows V1 = 11.8 m Maximum V 2. Vertical Termination - (continued) Three Elbows V H V INSTALLED HORIZONTALLY H 6 B. Wall Penetration Framing A. Pipe Clearances to Combustibles C. Vertical Penetration Framing 7 A. Securing and Leveling the Appliance 8 8 A. Assembly of Flue Sections B. Installing Firestops and Horizontal Termination Cap * 91 cm minimum in snow regions C. Install Roof Flashing and Vertical Termination Cap Page 9 A. Gas Pressure Requirements 9 B. Gas Connection 10 Heat & Glo Soho-CE 2111-900 Rev. D 6/07 23 A. Electronic Ignition System Wiring Figure 10.1 Electronic Ignition Wiring Diagram 11 11 A. Facing Material B. Mantel Projections 12 12 A. Remove Shipping Materials B. Clean the Appliance Page F. Glass Assembly 13 A. Before Lighting Appliance 13 B. Lighting the Fireplace LIGHTING INSTRUCTIONS CAUTION: WARNING: NOT FOR USE WITH SOLID FUEL C. After Appliance is Lit D. Frequently Asked Questions 14 14 A. Electronic Ignition System 15 15 A. Maintenance Tasks Inspect Maintenance Tasks 16 Appliance Dimensions Table 16 A. Appliance Dimension Diagram SOHO-CE B. Service Parts List SOHO-CE Service Parts SOHO-CE C. Limited Lifetime Warranty LIMITED LIFETIME WARRANTY HEAT & GLO GAS APPLIANCE PRODUCTS