Hearth and Home Technologies SOHO-CE F. Glass Assembly

Heat & Glo • Soho-CE • 2111-900 Rev. D • 6/07 27

Figure 12.10 Glass Assembly

F. Glass Assembly

Removing Glass Assembly

Pull the two lower and two upper glass assembly latches

out of the groove on the glass frame. Remove glass door

from the appliance (see Figure 12.10).

Replacing Glass Assembly

Replace the glass door on the appliance. Pull out and latch

the two glass assembly latches into the groove on the glass

frame on the bottom and top edges.

BOTTOM

LATCH

GLASS

ASSEMBLY

Handle glass doors with care.

• Inspect the gasket to ensure it is

undamaged.

• Inspect the glass for cracks, chips or

scratches.

• Do NOT strike, slam or scratch glass.

• Do NOT operate appliance with glass door removed,

cracked, broken or scratched.

• Replace glass door assembly as a complete appliance.

WARNING

Contents

Main Model: Soho-CE Installers Guide 0063-06 Congratulations Homeowner Reference Information Table of Contents 1 B. Non-Combustible Materials Speci cation C. Combustible Materials Speci cation A. Appliance Certi cation 2 A. Design and Installation Considerations 2 C. Inspect Appliance and Components B. Tools and Supplies Needed 3 A. Selecting Appliance Location NOTE: For actual appliance dimensions refer to Sec- tion 16. B. Constructing the Appliance Chase C. Clearances 4 A. Flue Termination Minimum Clearances A * 91 cm minimum in snow regions (See Figure 4.4 for speci c clearances) 4 Measure vertical clearances from this surface. Figure 4.2 speci es minimum ue heights for various pitched roofs. V = VENT TERMINAL X Alcove Applications 5 Horizontal B. Use of Elbows A. Flue Table Key C. Measuring Standards 1. Horizontal Termination One Elbow Two Elbows V H D. Flue Diagrams 1. Horizontal Termination - (continued) Three Elbows H V H V 2. Vertical Termination No Elbow Two Elbows V1 = 11.8 m Maximum V 2. Vertical Termination - (continued) Three Elbows V H V INSTALLED HORIZONTALLY H 6 B. Wall Penetration Framing A. Pipe Clearances to Combustibles C. Vertical Penetration Framing 7 A. Securing and Leveling the Appliance 8 8 A. Assembly of Flue Sections B. Installing Firestops and Horizontal Termination Cap * 91 cm minimum in snow regions C. Install Roof Flashing and Vertical Termination Cap Page 9 A. Gas Pressure Requirements 9 B. Gas Connection 10 Heat & Glo Soho-CE 2111-900 Rev. D 6/07 23 A. Electronic Ignition System Wiring Figure 10.1 Electronic Ignition Wiring Diagram 11 11 A. Facing Material B. Mantel Projections 12 12 A. Remove Shipping Materials B. Clean the Appliance Page F. Glass Assembly 13 A. Before Lighting Appliance 13 B. Lighting the Fireplace LIGHTING INSTRUCTIONS CAUTION: WARNING: NOT FOR USE WITH SOLID FUEL C. After Appliance is Lit D. Frequently Asked Questions 14 14 A. Electronic Ignition System 15 15 A. Maintenance Tasks Inspect Maintenance Tasks 16 Appliance Dimensions Table 16 A. Appliance Dimension Diagram SOHO-CE B. Service Parts List SOHO-CE Service Parts SOHO-CE C. Limited Lifetime Warranty LIMITED LIFETIME WARRANTY HEAT & GLO GAS APPLIANCE PRODUCTS