Hearth and Home Technologies SOHO-CE 10 , 10

Heat & Glo • Soho-CE • 2111-900 Rev. D • 6/07 23

BATTERY PORT

(4 AA BATTERIES)

VALVE

PILOT

IGNITION MODULE

6VDC

ON/OFF

SWITCH

THERMOCOUPLE

BLOCK

(CONNECTED TO

BACK OF VALVE)

PILOT GAS LINE

CONNECTED TO

BACK OF VALVE

IGNITION

MODULE

(6V)

ON/OFF

WALL SWITCH

VALVE

FLAME SPARKER/

SENSOR

ANT.

REMOTE

CONTROL

A. Electronic Ignition System Wiring

• This gas appliance is equipped with an electronic ignition

system which operates on a 6 volt system.

• The batteries are located within the ignition module which

is located under the unit. A wiring diagram is shown in

Figure 7.1.

• The battery pack requires four AA batteries (not

included).

Figure 10.1 Electronic Ignition Wiring Diagram

10

10 Electrical Information

CAUTION

Battery polarity must be correct or module damage will

occur.

CAUTION

Label all wires prior to disconnection when servicing controls.

Wiring errors can cause improper and dangerous operation.

Verify proper operation after servicing.

Shock hazard.

• Replace damaged wire with type 105º C rated wire.

• Wire must have high temperature insulation.

WARNING

Contents

Main Model: Soho-CE Installers Guide 0063-06 Congratulations Homeowner Reference Information Table of Contents 1 B. Non-Combustible Materials Speci cation C. Combustible Materials Speci cation A. Appliance Certi cation 2 A. Design and Installation Considerations 2 C. Inspect Appliance and Components B. Tools and Supplies Needed 3 A. Selecting Appliance Location NOTE: For actual appliance dimensions refer to Sec- tion 16. B. Constructing the Appliance Chase C. Clearances 4 A. Flue Termination Minimum Clearances A * 91 cm minimum in snow regions (See Figure 4.4 for speci c clearances) 4 Measure vertical clearances from this surface. Figure 4.2 speci es minimum ue heights for various pitched roofs. V = VENT TERMINAL X Alcove Applications 5 Horizontal B. Use of Elbows A. Flue Table Key C. Measuring Standards 1. Horizontal Termination One Elbow Two Elbows V H D. Flue Diagrams 1. Horizontal Termination - (continued) Three Elbows H V H V 2. Vertical Termination No Elbow Two Elbows V1 = 11.8 m Maximum V 2. Vertical Termination - (continued) Three Elbows V H V INSTALLED HORIZONTALLY H 6 B. Wall Penetration Framing A. Pipe Clearances to Combustibles C. Vertical Penetration Framing 7 A. Securing and Leveling the Appliance 8 8 A. Assembly of Flue Sections B. Installing Firestops and Horizontal Termination Cap * 91 cm minimum in snow regions C. Install Roof Flashing and Vertical Termination Cap Page 9 A. Gas Pressure Requirements 9 B. Gas Connection 10 Heat & Glo Soho-CE 2111-900 Rev. D 6/07 23 A. Electronic Ignition System Wiring Figure 10.1 Electronic Ignition Wiring Diagram 11 11 A. Facing Material B. Mantel Projections 12 12 A. Remove Shipping Materials B. Clean the Appliance Page F. Glass Assembly 13 A. Before Lighting Appliance 13 B. Lighting the Fireplace LIGHTING INSTRUCTIONS CAUTION: WARNING: NOT FOR USE WITH SOLID FUEL C. After Appliance is Lit D. Frequently Asked Questions 14 14 A. Electronic Ignition System 15 15 A. Maintenance Tasks Inspect Maintenance Tasks 16 Appliance Dimensions Table 16 A. Appliance Dimension Diagram SOHO-CE B. Service Parts List SOHO-CE Service Parts SOHO-CE C. Limited Lifetime Warranty LIMITED LIFETIME WARRANTY HEAT & GLO GAS APPLIANCE PRODUCTS