4 Getting Started | Installer Guide |
|
A. Typical Appliance System
NOTICE: Illustrations and photos reflect typical installations and are for design purposes only. Illustrations/diagrams are not drawn to scale. Actual product may vary from pictures in manual
Note: Dual venting configurations ARE NOT allowed. Appliance MUST be vented EITHER vertically OR horizontally.
MAINTAINS MINIMUM CLEARANCE
AROUND PIPE (SECTION 10.G)
VENT PIPE (SECTIONS 7 and 8)
CEILING FIRESTOP ON FLOOR OF ATTIC (SECTION 8.C)
FRAMING/HEADER (SECTION 5.B)
GAS LINE (SECTION 11)
HORIZONTAL
TERMINATION CAP (SECTION 10.L )
VERTICAL TERMINATION CAP (SECTION 10.I)
STORM COLLAR (SECTION 10.H)
VENT PIPE PENETRATES ROOF
PREFERABLY WITHOUT AFFECTING
ROOF RAFTERS (SECTION 8.C)
ATTIC INSULATION SHIELD (NOT SHOWN) MUST BE USED HERE TO KEEP INSULATION AWAY FROM VENT PIPE IF ATTIC IS INSULATED (SECTION 8.D)
FRAMING HEADED OFF IN CEILING JOISTS (SECTION 8.C)
REQUIRED ISOLATION SWITCH: AS5601
LOCATION WITHIN 1 METRE OF FIREPLACE,
SUBJECT TO MANTEL PIECE, ETC. CHECK
TO ENSURE IT REMAINS CLEAR ON ANY
MANTEL PIECE INSTALLATION.
OPTIONAL |
| |
WALL SWITCH |
| |
SECTION 12.C. |
| |
HEATER MUST BE INSTALLED AND | ||
MANTEL AND | ||
FLUE PENETRATION COMPLETE | ||
MANTEL LEG | ||
PRIOR TO FINISH SHEETING | ||
(SECTION 5.D) | ||
| ||
SURROUND |
|
HEARTH EXTENSION
Figure 4.1 Typical System
18 | Heat & Glo • |
|
