Adjusting Thermostat
•Press the MENU button to activate the menu.
•Using the UP and DOWN arrows highlight the THERMO icon and press SELECT.
•Use the UP and DOWN arrows to turn the THERMO ON or OFF, then press SELECT (the SET TEMP will start blinking). Using the UP and DOWN arrows select the desired temperature and press SELECT.
NOTICE: If the THERMO function is on, the SET TEMP can be adjusted at any time by pressing the UP and DOWN arrows.
NOTICE: As the ROOM TEMP (RT) approaches SET TEMP (ST), the remote system will automatically adjust the flame height. If the RT rises above ST, the fireplace will shut down the main burner. After this, the fireplace will turn back on after the RT drops below the ST.
NOTICE: The system will remember the previous TEM- PERATURE setting when THERMOSTAT mode is cycled ON or OFF.
NOTICE: If your installation includes an optional wired ON/ OFF wall switch, it should be in the OFF position when using the RC300AU in thermostat mode.
Adjusting Timer
•Press the MENU button to activate the menu.
•Using the UP and DOWN arrows highlight the TIMER icon and press SELECT.
•Use the UP and DOWN arrows to turn the TIMER ON or OFF, then press SELECT. Using the UP and DOWN arrows select the desired set time and press SELECT. Timer operates in increments of 15, 30, 45, 60, 90, 120 and 180 minutes.
Setting the Child Lock
•Press and hold the MENU and UP arrow buttons simul- taneously for 4 seconds to enable or disable the child lock feature.
NOTICE: No functions will be usable until child lock feature is disabled.
Power Outage
•If fireplace battery backup system IS installed at time of power outage, fireplace operation will not be interrupted.
•If fireplace battery backup system IS NOT installed at time of power outage, fireplace will shut off. To resume fireplace operation, install battery backup.
NOTICE: Battery polarity must be correct or module damage will occur.
Manual Fireplace Shutoff
In the unlikely event that the remote wall switch malfunc- tions and will not turn off the fireplace, call your dealer for service assistance. In the meantime, you may choose one of the following actions to turn off the fireplace:
CAUTION! Risk of burns! Fireplace surfaces are hot when operating and during cool down. Use care and wear gloves when opening the front and accessing com- ponents inside the fireplace.
Check remote screen for battery level indicator, replace the batteries if low battery is indicated (See Figure 12.12).
Turn off the control module:
•Open or remove the decorative front to access the control module.
•Move switch to OFF (See Figure 12.10).
Disconnect power to the control module:
•Open or remove the decorative front to access power cord and/or
•Unplug the control module and/or remove
Shut off gas to the appliance:
•Open or remove the decorative front and locate the gas
•Rotate the shut off valve 90 degrees to turn off gas supply.
Turn off power to the fireplace (if
•Locate house circuit breaker for fireplace.
•Turn off the circuit breaker.
Heat & Glo • | 61 |
