E. Covers Removal For Servicing
Control Compartment Access Door
•Lift the lower door up and out to access the gas controls.
Trim Door and Glass Door
•Lift the front trim door up and out away from the appliance side surrounds. Replace the door when servicing is complete.
•Noting carefully how the brackets fit on the glass, release the two spring latches at the top and two at the bottom of the glass door. Carefully lift the glass up and out away from the appliance. See Figure 9.17.
Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fixed glass assembly with care. Inspect the gasket to ensure it is undamaged and inspect the glass for cracks, chips or scratches.
•DO NOT strike, slam or scratch glass.
•DO NOT operate fireplace with glass removed, cracked, broken or scratched.
•Replace as a complete assembly.
Removing Fixed Glass Assembly
•Pull the four glass assembly latches out of the groove on the glass frame. Remove glass door from the appliance (see Figure 9.17).
Replacing Fixed Glass Assembly
•Replace the glass door on the appliance. Pull out and latch the four glass assembly latches into the groove on the glass frame.
LATCHES |
(BOTH BOTTOM |
AND TOP) |
GLASS
ASSEMBLY
Figure 9.17 Fixed Glass Assembly
F. Components Removal For Service
•Release the screws at the base of the log grate and carefully lift up and remove the logs and log grate.
•Remove the base pan.
•Unscrew the brackets at both ends of the burner and the top two screws locating the pilot bracket (see Figure 9.18). Slide the burner away from the burner orifice.
PILOT BRACKET |
RETAINING SCREWS |
Figure 9.18
NOTICE: All screws which were removed must be replaced.
Pilot Assembly/Ignition System
•Remove the log set, log grate and burner assembly.
•Disconnect the gas supply tube from the outlet side of valve.
•Disconnect the orange ignitor wire (I) and white sensor wire (S) from module.
•Unscrew the pilot assembly bracket and remove, the pilot assembly along with silicone sealant grommet.
G. Parts Replacement
Fan
•Unplug the fan from the AUX300CE and slide the fan out the front of the lower controls compartment.
•Fan can be operated at 3 speed levels using RC300AU remote and AUX300CE. Refer to RC300AU section.
•The fan will automatically turn on after 3 minutes and will stop 12 minutes after unit has been turned off.
Glass Panel
•To replace the glass door, place the bottom edge into the lower holders, push glass against unit and secure the two spring latches at the top and bottom.
H. Adjustments And Replacement Parts
Adjustments and replacement parts for this appliance should only be done by a qualified service person. A wir- ing diagram for the appliance is shown in Section 12. A service parts list is shown in Section 16 of this manual.
I. Install Trim and/or Surround
•Install optional trim kits and/or surrounds using the instructions included with the accessory.
•Use
J. Air Shutter Setting
| Natural Gas | Propane | Butane |
| 11.13 mm | N/A | N/A |
| N/A | Full Open | Full Open |
44 | Heat & Glo • |
|
