Heat & Glo LifeStyle 6000GCF-IPILP owner manual Junction Box Installation

E. Junction Box Installation

If the box is being wired from the appliance:

•Remove the screw attaching the junction box to the outer shell, rotate the junction box inward to disengage it from the outer shell (see Figure 10.2).

•Pull the electrical wires from outside the appliance through this opening into the valve compartment.

•Loosen the two screws on the Romex connector (not included with unit), feed the necessary length of wire through the connector and tighten the screws.

•Make all necessary wire connections to the receptacle and assemble the receptacle and cover to the junction box.

	Romex
	Connector
	14/2WG
	Cover Plate
	outside firebox
WHT
BLK
WHT
BLK	Copper
GRN wire	ground attached
	to GRN screw with
inside box	GRN wire
	NOTE: Do NOT wire
Figure 10.2 Junction Box Detail	110VAC to wall switch.

F. Wall Switch Installation for Fan (Optional)

If the box is being wired to a wall mount-
ed switch for use with a fan (See Fig-
ure 10.4):			SWITCH
•	The power supply for the appliance must
		MINIMUM 14-3 AWG
	be brought into a switch box.	WITH GROUND
• The power can then be supplied from		Red	Black
		Black
	the switch box to the appliance using a	White	White
		Green	Green
	minimum of 14-3 with ground wire.	JUNCTION BOX
•	At the switch box connect the black (hot)	Red Black White Green
	wire and red (switch leg) wire to the wall
			POWER
	switch as shown.		SUPPLY WIRES
•	At the appliance connect the black (hot),		SWITCH BOX
	white (neutral) and green (ground) wires
	to the junction box as shown.
• Add a 1/4 inch insulated female connector
	to the red (switch leg) wire, route it through	Red
	the knockout in the face of the junction
	box, and connect to the top fan switch
	connector (1/4 inch male) as shown.	Figure 10.4 Junction Box Wired to Wall Switch
	Heat & Glo • 6000GCF-IPI, 6000GCF-IPILP • 2110-900 Rev. F • 6/08		33