2

Figure 12.12 Front View

2

Figure 12.13 Top View

STEP 4. Log #2 (SRV2103-108):Place log #2 on top of the left side of log #1. The bottom of this log has a slot in it that goes over the tab molded into the top of log #1. The left end sits behind the simulated ember cluster on the burner top.

3

Figure 12.14 Front View

3

Figure 12.15 Top View

STEP 5. Log #3 (SRV2103-110):Place log #3 on top of the burner surface in front of the hump. The bottom of the log has a square groove cut through it. The groove sits over the second grate tine from the left. Slide it back against the hump.

4

Figure 12.16 Front View

4

Figure 12.17 Top View

STEP 6. Log #4 (SRV2103-109):Place log #4 on top of the right side of log #1. The bottom of this log has a slot in it that goes over the tab molded into the top of log#1. The other end of the log rests on the grate, against the second tine from the right.

5

Figure 12.18 Front View

5

Figure 12.19 Top View

STEP 7. Log #5 (SRV2103-111):Place log #5 in front of log #3 the notch in the bottom of this log rests over the center tine on the grate. The log shouldn’t cover any ports.

38

Heat & Glo • 6000GCF-IPI, 6000GCF-IPILP2110-900 Rev. F • 6/08

Page 38
Image 38
Heat & Glo LifeStyle 6000GCF-IPILP owner manual Front View