D. Elevated Hearth Systems

Use the table below to identify the hearth system that will be used. The table will also help identify effects on the various dimensions. Some hearth systems will elevate the appliance off the floor at a given dimension. The dimension noted in the table below, in the Elevated Appliance Dimension Column, will also have to be added to the following: Extension Wall Hole referenced in Figure 8.2 (Exterior Wall Hole) and Rough Opening Height (header height) referenced in Figure 5.2. Note: Finished floor thickness should also be considered when determining installation dimensions.

MODEL

DESCRIPTION

PART #

ELEVATED APPLIANCE DIMENSION

See Note 1

 

 

 

 

Avalon Cast Mantel

AFANTC5244

1/2 in.

ESC-42ST

Biltmore Cast Mantel

AFBETC5244

1/2 in.

 

Hearst Cast Mantel

AFHTTC5244

1/2 in.

Note 1. Add dimensions to Exterior Wall Hole (Figure 8.2) and Rough Opening Height (Figure 5.2).

The above listed Hearth and Home Technologies manufactured hearth systems have been tested and certified for use with the ESC-42ST fireplace. The dimensions of these Hearth and Home Technologies manufactured hearth systems may differ slightly from the mantel specifications listed in Section 5.D and Section 13.A. The above listed Hearth and Home Technologies manufactured hearth systems are not required to meet the mantel specifications listed in Section 5.D and Section 13.A.

46

Heat & Glo • ESC-42ST2146-900 Rev. o • 5/12

Page 46
Image 46
Heat & Glo LifeStyle ESC-42ST owner manual Elevated Hearth Systems, Model Description Elevated Appliance Dimension