Heat & Glo LifeStyle ESC-42ST owner manual  4

2		1
	5	
3		FRONT LOG 4

NOTCH

Figure 12

LOG NUMBER 5 (SRV2146-705):Place Log #5 from side of unit where pilot is located on your right side. Place log so the front log notch engages the center grate tine as shown in Figure 12 and the right side of log rests on the notch in Log #4. See Figure 11. The notch is visible in Figure 11. The log must NOT block or sit directly over any burner ports.

4	5	3
7
1		2

Figure 13

LOG NUMBER 7 (SRV2146-707):Log #7 rests on the notch on top of log #1 and the notch on top of log #4. See Figure 13. The points of contact on Log #1 and Log #4 where Log #7 rests are indicated by the circles in Figure 10.

 4 7	5	3
1	6	2

Figure 14

LOG NUMBER 6 (SRV2146-706):Place Log #6 onto grate and log #1. The groove on the bottom of the log will engage the center grate bar and the other end of the log will rest on Log #1, with the tip touching Log #7. The points of contact are indicated by the circles located on Log #6 and Log #7 in Figure 14. The log must NOT block or sit directly over any burner ports.

4	5	3
 7			8
		2

1 6

Figure 15

LOG NUMBER 8 (SRV2146-708):Locate notch on Log #2 and notch on Log #3 indicated by the circles on Figure 14. Place Log #8 so that it rests in these notches. See Figure 15.

4		BURNT AREA
	7	5	3
		9		8
	1	6		2

Figure 16.

LOG NUMBER 9 (SRV582-707):Place log #9 onto Log #2 and Log #5. The “burnt area” of log 9 will face the pilot side of the log assembly.

54 Heat & Glo • ESC-42ST • 2146-900 Rev. o • 5/12