14 Appliance Setup
A. Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Glass installation and removal should be performed only by a qualified service technician. Handle fixed glass assembly with care. In- spect the gasket to ensure it is undamaged and inspect the glass for cracks, chips or scratches.
•DO NOT strike, slam or scratch glass.
•DO NOT operate fireplace with glass removed, cracked, broken or scratched.
•Replace as a complete assembly.
Installing Fixed Glass Assembly
1.Identify the top and bottom of the glass assembly. The top of the glass frame has three engagement grooves. The engagement groove is highlighted in Figure 14.1.
3.With the glass assembly resting (not engaged) on the bottom glass latch tabs, allow for the top of the glass assembly to tip away from the fireplace. Lift up slightly and ensure the glass assembly bottom seal is tight to the bottom of the firebox. See Figure 14.3.
Figure 14.1 Glass Top Tab Detail.
2.Start by tipping the top of the glass frame toward the fireplace. Center the glass between the left and right firebox supports. Push “up” and “in” and set the glass assembly on the bottom three glass latch tabs. See Figure 14.2 .
Figure 14. 2 Initial Positioning of Frame into Opening.
Figure 14.3 Second Position of Frame into Opening.
4.Engage the bottom glass latch tabs into the three slots in the bottom of the glass frame.
To engage the tabs into the frame slots, manipulate the glass clips by pulling out the glass latch handles. Figure 14.3 shows the middle glass latch tab engaged.
Engage an end latch first, then middle latch, and finally the last end latches.
TAB
HANDLE
Figure 14.4 Glass Latch Engaged into Frame Latch.
Heat & Glo • | 47 |
