Heat & Glo LifeStyle ESC-42ST owner manual DVP-TRAP1 DVP-TRAP2 DVP-TRAPK1 DVP-TRAPK2, Dvp-Trap

B. Vent Components Diagrams (continued)

Note: Heat shields MUST overlap by a minimum of 1-1/2 in. (38 mm). The heat shield is designed to be used on a wall 4 in. to 7-1/4 in. (102 mm to 184 mm) thick. If wall thickness is less than 4 in. (102 mm) the existing heat shields must be field trimmed. If wall thickness is greater than 7-1/4 in. (184 mm) a DVP-HSM-B will be required.

15-1/8 in.

(384 mm)

12 in. (305 mm)

DVP-TRAP

Horizontal Termination Cap

8 in.

(203 mm)Heat Shield

			Term Cap		Minimum		Maximum
				Effective Length			Effective Length
		Max
					3-1/8 in.		4-5/8 in.
Effective			Trap1
						79 mm	117 mm
	Length
			Trap2		5-3/8 in.		9-3/8 in.
					137 mm		238 mm

DVP-TRAP1 DVP-TRAP2

DVP-TRAPK1 DVP-TRAPK2

Figure 16.3 DVP vent components

Heat & Glo • ESC-42ST • 2146-900 Rev. o • 5/12 61