Heat & Glo LifeStyle ESC-42ST owner manual Install Refractory, Notch, Flange

G. Install Refractory

CAUTION: Refractory pieces are fragile! Carefully remove the refractory pieces from the packaging.

1.Locate the four refractory clips pre-installed in the top of the firebox and remove. Install side refractory with the notched end of the refractory on the bottom. See Figure 14.14 and Figure 14.15. Ensure that side refractory panels are centered left and right and do not extend past the outer firebox flange. Secure each side refractory with two refractory clips.

NOTCH

Figure 14.14 Notched End of Side Refractory

2.Install the left and right refractory middle base refractory pieces on top of the left and right bottom refractory standoffs. See Figure 14.16 and 14.17. Position so that the edge is flush with the ember light housing.

Figure 14.16 Positioning Inner Bottom Refractory

FLANGE

Figure 14.17 Positioning Left and Right Middle Base Refractory

OUTER FIREBOX

FLANGE

REFRACTORY

CLIPS

Figure 14.15 Refractory Clip Installation

Figure 14.18 Positioning Outer Bottom Refractory.

5. Install two outer bottom refractory pieces as shown in Figure 14.18. Ensure that outer bottom refractory pieces do not extend past the outer firebox flange.

50 Heat & Glo • ESC-42ST • 2146-900 Rev. o • 5/12