Heat & Glo LifeStyle SL-750TRS-IPI-D owner manual Framing the Appliance, Framing Dimensions

Step 2. Framing the Appliance

Appliance framing can be built before or after the appliance is set in place. Framing should be positioned to accommo- date wall coverings and appliance facing material. The dia- gram below shows framing reference dimensions.

CAUTION: MEASURE APPLIANCE DIMENSIONS AND VERIFY FRAMING METHODS AND WALL COVERING DETAILS BEFORE FRAMING.

VENT

FRAMING

HOLE

*The center of the framing hole is one (1) inch (25.4mm) above the center of the hori- zontal vent pipe.

The framing headers may rest on the appliance stand-offs.

E D *

Framing should be constructed of 2 X 4 lumber or heavier.

Models	A	B	C	D	E
SL-750TRS-IPI-D	42”	38 1/4”	16 1/4”	41”	27 7/8”
SL-550TRS-IPI-D	37”	33”	16 1/4”	36 1/2”	24 3/8”
SL-350TRS-C	34”	31”	16 1/4”	35 1/2”	22 3/8”

B

C

A

3”

WALL STUD

NON-COMBUSTIBLE ZONE

2-1/4”IS DEFINED BY 3” ABOVE THE ELBOW FOR THE ENTIRE

WIDTH AND DEPTH (BEHIND THE

FRONT HEADER) OF THE FIREBOX.

Figure 5. Framing Dimensions

Heat & Glo • SL-350TRS-C, SL-550/750TRS-IPI-D • 2065-985 Rev. J • 5/06 19