The filter switch is a two way rocker switch with the switch in the “ON” position, the filter motor energizes to pump up the shortening from the drain pan.
1.Remove power supplied to the unit, or on electric models, to the far right cookpot that powers the filter switch.
Disconnect power supplied to the unit by unplugging the power cord, or turning off the wall circuit breaker or fuse. Be aware that the other control will have power on electric models, or electrical shock could result.
2.Remove the middle control panel per section 6-3.
3.Remove and label wires from the switch and check across top and bottom terminals for continuity. With the switch in the “ON” position, the circuit should be closed. If the switch is defective, replace it by following the next steps.
4.Push in tabs on the ends of the switch and pull switch from the front of the control panel.
5.Replace new switch, replace wires, and install panel.
6.
