WARNING: Always firmly clamp or vise to secure the crown molding to the fence; otherwise the crown molding might be thrust from the table and cause bodily harm.
Do not perform bevel cutting. The main body or the saw blade may contact the sub fence, resulting in an injury.
CAUTION: Always confirm that the motor head does not contact the crown molding vise ass’y when it is lowered for cutting. If there is any danger that it may do so, loosen the 6 mm knob bolt and move the crown molding vise ass’y to a position where it will not contact the saw blade.
Position crown molding with its WALL CONTACT EDGE against the guide fence and its CEILING CONTACT EDGE against the crown molding stoppers as shown in Fig.
Table 9
| Position in Fig. 26 | Miter angle | Finished piece | |
For inside corner | 1 | Right 45° | Save the right side of blade | |
| 2 | Left 45° | Save the left side of blade | |
For outside corner | 3 | Save the right side of blade | ||
| ||||
| 4 | Right 45° | Save the left side of blade |
