■ Setting the Batteries
1 |
|
| Open the battery/SD memory card cover by |
|
| ||
|
|
| sliding it in the direction of the arrow. |
| |||
|
|
|
|
2 | Set the batteries by aligning the + and |
| marks with the marks in the battery |
| compartment. |
3 |
|
| Close the battery/SD memory card cover. |
|
| ||
|
|
|
|
●Turn off the camera power before replacing the batteries.
●Do not open the battery/SD memory card cover using a violent motion. The cover may be damaged.
●When opening/closing the battery/SD memory card cover, be careful not to drop the batteries.
●It is recommended that the batteries be removed and stored separately if the camera won,t be used for a long period of time.
Applicable Batteries
The
●AA manganese dry batteries cannot be used.
●The two AA alkaline dry batteries included in the package are provided to help you check the basic operations of the digital camera. If you are shooting real targets, replace them with commercial AA alkaline dry batteries or AA nickel metal hydride batteries.
Reference Battery Life （Kept with LCD monitor on and internal memory in use）
Battery type | Continuous |
| Cyclic | Playback time | |||
|
|
|
| ||||
Flash | No flash | ||||||
|
|
|
| ||||
|
|
|
|
| |||
AA alkaline dry battery LR6 | Approx. 900 images | Approx. 200 images | Approx. 500 images | Approx. 190 minutes | |||
●The figures in the table are reference values until the batteries go flat, assuming that images are captured in a standard environment in the 2304 x 1728/normal mode under the following conditions and played continuously at a speed of approximately 3 seconds per frame. They are not guaranteed. The actual figures may be lower, depending on the condition or environment in which the camera is used.
［Continuous］Images are captured continuously without flash. ［Cyclic］Images are captured by repeating the sequence of
“Checking the subjects for 5 seconds”→“Capture”→“Playback for 5 seconds.” ※In both modes, all images are erased once the memory gets full.
●Even when the power is off, the
Remaining Battery Power Display
Full battery power 
Low battery power
Running out of battery
（In this condition the flash or Formatting P74 may not work properly. It is recommended that you replace the batteries with new ones.）
No battery. Replace with new batteries.
Displayed when the AC adapter (sold separately) is in use.
●The remaining battery power may not be displayed correctly, depending on the use condition and environment in which the camera is used.
●Use the display of remaining battery power only as a reference.
Basic Operations Getting Ready
17 | 18 |
