Note: See "Imager Models" on page
1.Turn off power to the terminal/computer.
2.Connect the appropriate interface cable to the imager.
Note: For the imager to work properly, you must have the correct cable for your type of terminal/computer.
3.Plug the serial connector into the serial port on your computer. Tighten the two screws to secure the connector to the port.
4.Plug the power supply into the cable.
5.Once the imager has been fully connected, power up the computer.
6.Program the imager for an
Note: See "Imager Models" on page
Your imager uses True and TTL signal levels to wedge into an
1 - 6