1.Turn the power to the host system OFF.
2.Disconnect the imager’s cable from
the terminal or computer.
3. Rotate the imager downward to the last position.
4. Locate the small hole on the side of the stand. This is the cable release.
5. | Straighten one end of a paper clip. | Cable |
|
| |
6. | Insert the end of the paper clip into the | Release |
| small hole and press in. This |
|
depresses the retention tab, releasing the connector. Pull the connector out while maintaining pressure on the paper clip, then remove the paper clip.
7.Replace with the new cable.
Insert the connector into the opening and press firmly. The connector is keyed to go in only one way, and will click into place.
To Replace the 4800i Interface Cable:1.Turn the power to the host system OFF.
2.Disconnect the imager’s cable from the terminal or computer.
3.Use a screwdriver to unscrew the cord lock from the base of the imager.
4.Locate the small hole on the side of the imager’s handle. This is the cable release.
5.Straighten one end of a paper clip.
6.Insert the end of the paper clip into the small hole and press in. This depresses the retention tab, releasing the connector. Pull the connector out while maintaining pressure on the paper clip, then remove the paper clip.
Cable
Release
Cord lock
7.Replace with the new cable.
Insert the connector into the opening and press firmly. The connector is
keyed to go in only one way, and will click into place.
14 - 3