Imager
0.Scan Imager
Note: The default applies to firmware with a base number of 31205480. Refer to the Show Software Revision on page
Imager
The aimer delay allows a delay time for the operator to aim the imager before the picture is taken. Use these codes to set the time between when the trigger is pulled and when the picture is taken. During the delay time, the aiming light will appear, but the LEDs won’t turn on until the delay time is over. Default = Off.
200 milliseconds
400 milliseconds
*Off (no delay)
If you want to set your own length for the duration of the delay, scan the bar code below, then set the
Delay Duration
3 - 12