Trigger Commands

You can activate and deactivate the imager with serial trigger commands. First, the imager must be put in Manual/Serial Trigger Mode either by scanning the Manual/Serial Trigger Mode bar code (page 3-4), or by sending the Manual/ Serial Menu Command (page 12-9). Once the imager is in serial trigger mode, the trigger is activated and deactivated by sending the following commands:

Activate: SYN T CR

Deactivate: SYN U CR

The imager scans until a bar code has been read, until the deactivate command is sent, or until the serial time-out has been reached (see "Read Time-Out" on page 3-4for a description, and the serial command on page 12-9).

Resetting the Standard Product Defaults

If you aren’t sure what programming options are in your imager, or you’ve changed some options and want the factory settings restored, scan the Standard Product Default Settings bar code below.

Standard Product Default Settings

The chart on the following pages lists the factory default settings for each of the menu commands (indicated by an asterisk (*) on the programming pages).

Menu Commands

Note: Not all menu commands apply to all imager models.

 

Setting

Serial

 

Selection

Command

Page

* Indicates default

# Indicates a

 

 

 

 

numeric entry

 

 

 

 

 

 

 

 

 

Factory Default

Default

DEFALT

12-4

Settings

 

 

 

 

 

 

 

Terminal Interfaces

 

 

Terminal ID

000 (4600g/4600r/4600rp/

TERMID###

2-1

 

4800i 030 models)

 

 

 

124 (4600g/4600r/4600rp/

 

 

 

4800i 050 models)

 

 

 

 

 

 

12 - 4