You can temporarily disable the secondary interface, but still retain the secondary interface settings in the imager’s memory by scanning the Disable bar code below. To
Default =Disable.
* Disable
Enable
SecondaryAll communication parameters between the imager and terminal must match for correct data transfer through the serial port using
Note: See "Imager Models" on page
In Wand Emulation mode, the imager decodes the bar code then sends data in the same format as a wand imager. The Code 39 Format converts all symbolo- gies to Code 39. The Same Code Format transmits UPC, EAN, Code 128, Codabar, and Interleaved 2 of 5 without any changes, but converts all other symbologies to Code 39. 2D symbologies are converted to Code 128. These codes set the transmission rate to 25 inches per second and the output polarity to black, high. Default = Code 39 Format.
6 - 2