Honeywell EN2H-0221GE51 R0808 Night-time room temperature button, Factory setting 50 C

SDC / DHC Operation

5.1.2.3"Night-time room temperature" button

Sets the lowered room temperature in automatic mode between

¦the heating cycles and in the ABSENT and RED. HEATING operating modes.

In operating mode 1, the set value for all heating circuits is the same. In operating mode 2, the set value applies for the respective heating circuit. To set the operating mode, see 5.2.3.3 Operating mode, pg. 74.

Setting

C

►Press ¦ button.

►Set flashing room temperature specification to the desired value by turning the input button î.

►Confirm set value by pressing the ¦ button or the input button î.

Alternative: Automatic acceptance of the value after the set information time (see 5.1.2.7 "System information" button, pg. 35).

Factory setting

Setting range

5.1.2.4

§

16 °C

5 ... 30 °C

"Daytime hot-water temperature" button

Sets the daytime hot-water temperature during the hot-water operational-readiness times in automatic mode and in the PARTY and HEATING operating modes. This set value also applies for exclusively hot-water operation (manual summer operation).

Setting

C

►Press § button.

►Set flashing hot-water temperature to the desired value by turning the input button î.

►Confirm set value by pressing the § button or the input button î.

Alternative: Automatic acceptance of the value after the set information time (see 5.1.2.7 "System information" button, pg. 35).

Factory setting 50 °C

EN2H-0221GE51 R0808 25