Honeywell EN2H-0221GE51 R0808 Parameter 46 pre-heating time at 0C, Parameter 47 lowering ramp

Hydraulic Components SDC / DHC

Parameter 46 pre-heating time at 0°C

By setting the quick heat-up time at an outside temperature of 0°C, the heat-up speed affected. This value is included in the calculation of the pre-heating time.

Pre-heating time = pre-heating time 0°C/20°C x (room setpoint – outside temperature)

Parameter 47 lowering ramp

This parameter setting specifies how fast the temperature is reduced before the end point of the heating cycle is reached, e.g. 10 p.m.

Switch-on optimisation with room sensor (adaptation)

	a
20 C
16 C
4:30	6 h 7 h	16 h	17 h
		b
		c

a	Calculation via the	b min. pre-heat time
	controller
c	max. pre-heat time

Switch-on optimisation without room sensor

a		b
20 C
16 C
6 h 7 h	16 h	17 h
	c

174 EN2H-0221GE51 R0808