Honeywell EN2H-0221GE51 R0808 service manual Time program, Set values Factory setting Effects

SDC / DHC Operation

5.2.3.2Time program

This parameter specifies enabling of the switching time programs for program selection and for individualised switching time programming. In the state of delivery, only one switching time program is enabled. This achieves simplification of operation with a large portion of applications for which only one switching time program is used.

Set values

Factory setting

Effects

P1 Program 1 = enabled, programs 2 and 3 = disabled P1 to P3 All three programs enabled

P1

In contrast to the previous description, the following setting options are available when programs P1 to P3 are enabled:

•Operating mode selection: In the AUTOMATIC and SUMMER operating modes, switching time program P1, P2 or P3 can be selected.

•Switching time programming: With switching time pro- gramming, the three switching time programs, P1 to P3, can be selected for each heating circuit.

5.2.3.2.1Control mode selection

In the AUTOMATIC and SUMMER control modes, switching time program P1, P2 or P3 can be selected.

5.2.3.2.2Switching time programming

With switching time programming, the three switching time programs, P1 ... P3 can be selected.

EN2H-0221GE51 R0808 73