HP ProCurve 2610 N o t e, Switch the Installing, Figure 2-2.Checking the LEDs on the 2610 non-PWRswitches

				Installing the Switch
			Installation Procedures
N o t e	The 2610 Switches do not have a power switch. They are powered on when
	the power cord is connected to the switch and to a power source. For safety,
	the power outlet should be located near the switch installation.
	The switch automatically adjusts to any voltage between 100-127 or 200-240
	volts and either 50 or 60 Hz. There are no voltage range settings required.
	If your installation requires a different power cord than the one supplied with
	the switch, be sure the cord is adequately sized for the switch’s current
	requirements. In addition, be sure to use a power cord displaying the mark of
	the safety agency that defines the regulations for power cords in your country.
	The mark is your assurance that the power cord can be used safely with the
	switch. If the PWR device’s supplied power cord does not fit, contact ProCurve
	Networking support.
	2. Check the LEDs on the switch as described below.
			Switch port LEDs
		Self Test LED

Power and

Fault LEDs

Figure 2-2. Checking the LEDs on the 2610 non-PWR switches

Switch the Installing

2-7