Installing the Switch

Installation Procedures

Flat Wall Mounting

Installing the Switch

W A R N I N G

C a u t i o n

W A R N I N G

There are two switches in this series that can be wall mounted, the J9085A 24- port Non-PoE and the J9088A 48-port Non-PoE. You can mount these switches on a wall as shown in the illustration Figure 2-8. Wall mounting is not supported for the 2610-PWR switches because of the size and weight of the devices. See page 2-14for instructions.

For safe operation do not install the switch with either side vent holes (vertical) facing downward. Do not wall mount the 2610-PWR switches.

The switch should be mounted only to a wall or wood surface that is at least 1/2-inch (12.7 mm) plywood or its equivalent.

Supported Wall Mounting Positions.

Switch

Vertical Wall Mounting

Horizontal Wall Mounting

 

 

 

2610 Non-PWR

No

Yes

2610-PWR

No

No

The Switch 2610-PWR Switches are not wall mountable.Wall mounting Horizontal

1.Use a #1 Phillips (cross-head) screwdriver and attach the mounting brackets to the switch with the included 8-mm M4 screws.

2.Attach the switch to the wall or wood surface with two 5/8-inch number 12 wood screws (not included).

2-14