C a u t i o n

C a u t i o n

Installing the Switch

Installation Procedures

RJ-45 Ports

Wall

M4 screws

5/8-inch

wood screws

Figure 2-8. Horizontal wall mounting

The J9088A 48-port, non-PWR switch can be wall mounted with either the RJ-45 ports side up or down in the horizontal orientation. A vertical wall mount orientation is not supported.

The J9085A 24-port, non-PWR switch can be wall mounted with the RJ-45 port side facing down only in the horizontal orientation. A vertical wall mount orientation is not supported.

Horizontal Surface Mounting

Place the switch on a table or other horizontal surface. The switch comes with rubber feet in the accessory kit that can be used to help keep the switch from sliding on the surface.

Attach the rubber feet to the four corners on the bottom of the switch within the embossed angled lines. Use a sturdy surface in an uncluttered area. You may want to secure the networking cables and switch power cord to the table leg or other part of the surface structure to help prevent tripping over the cords.

Ensure the air flow is not restricted around the sides and back of the switch.

Switch the Installing

2-15