HP 445 manual Set-Up Requirements for Quick Remote

How To Use Quick Remote

Introducing Quick Remote

Set-Up Requirements for Quick Remote

The following is needed to enable Quick Remote operation:

		The central router on which you are going to create the Quick
		Remote configuration(s) must already be configured for HP Point-to-
		Point routing on the WAN ports that you will use for Quick Remote
		access from remote routers. (The Quick Remote configurations that
		you create are assigned to these WAN ports on the central router for
		downloading to remote routers, but do not affect the configuration
		of these ports.)
		An active HP Point-to-Point WAN link must exist between a WAN
		port on a remote router and a WAN port on a central HP router.
		A minimal IP and/or IPX configuration must be stored in Quick
		Remote on the central router for the WAN port linked to a WAN port
		on the remote router
		The remote HP router must be configured to the factory default
		prior to power-up or rebooting
N o t e	‘‘Factory default’’ is the state of the router configuration either when the
	router is shipped from the factory or when you use the Clear/Reset
	button combination (described in the installation manual) to clear the
	configuration and reboot the router.

8-4