HP 445 manual HP Router 650 How To Update, Interface Module Configuration After

How To Use Quick Configuration

Operating Notes

	The HP Router 650: How To Update the
	Interface Module Configuration After
	Removing or Replacing a Module
	Interface modules in an HP 650 router can be inserted, removed, or
	replaced while the router is operating. However, when one of these
	actions results in either no replacement for a removed module or
	replacement with a module having a different set of ports, then the
	software configuration will not match the current hardware
	configuration. This subsection describes how Quick Configuration
	operates in these conditions and how to use Quick Configuration to
	update the interface module configuration after removing or replacing a
	module.
N o t e	Quick Configuration reacts to a change in interface modules only when
	the change takes place before you start Quick Configuration. That is, if a
	module change occurs while Quick Configuration is in use, the effects of
	the change will not appear in Quick Configuration until you exit from
	Quick Configuration and then restart it.
	Rebooting the router causes the router to re-initialize itself by using the
	most recently saved configuration. Thus, after removing or replacing a
	interface module, rebooting the router does not update the interface
	module configuration unless you have also used Quick Configuration (or
	the Configuration Editor) to update and save the router’s configuration.

3
Configuration	Quick

3-31