HP 445 manual T e

N o t e

N o t e

How To Use Quick Configuration

How To Configure for X.25

3.Specify the X.25 circuit type—DDN, PDN, or PTOP (the default). (If you don’t want PTOP, type ddn or pdn for the type of X.25 circuit, then press [Return].)

∙If you specified DDN for the circuit type, no more parameters are needed for the default configuration. Go to step 4 on page 3-22.

∙If you specified PDN, you will need to enter the local DTE address, the IP address, and the X.121 address, as follows:

Use the [Return] key to bypass fields that already contain default values.

–Local DTE address for PDN: Type / l (the [/] and [L] keys), enter the X.121 address of the local port at ‘‘Local DTE Address’’, and press [Return] as many times as needed to return to Quick Configuration. (Refer to figure 3-15 on page 3-21.)

–IP address and X.121 address for PDN: Type / r, enter the IP address and X.121 address of the remote port, and press the [Return] key as many times as needed to return to the Quick Configuration screen. (Refer to figure 3-16 on page 3-21.)

∙If you specified PTOP, you will need to enter the local DTE address, the remote DTE address, and the connection ID, as follows:

–Local DTE address: Type / l (the [/] and [L] keys), enter the X.121 address of the local port (at ‘‘Local DTE Address’’), and press [Return] as many times as needed to return to the Quick Configuration screen. (Refer to figure 3-17 on page 3-22.)

–Remote DTE address and Connection ID: Type / r, enter the X.121 address (at ‘‘Remote DTE Addr’’) and the Connection ID of the remote port, then use [Return] to return to the Quick Configuration screen. (Refer to figure 3-18 on page 3-22.)

If you want to add more connection IDs, type / l instead of / r. Then use [Return] to step past Local DTE Address. When you see ‘‘1. X.25 Virtual Circuits’’, type 1 and press [Return], then select the ‘‘Add’’ op- tion. For more on how to use the Configuration Editor, refer to chapter 4.

3-20