HP 4500 - K7 manual Test fax setup, To test fax setup via the device control panel

Appendix C

Test fax setup

You can test your fax setup to check the status of the device and to make sure it is set up properly for faxing. Perform this test after you have completed setting up the device for faxing. The test does the following:

•Tests the fax hardware

•Verifies the correct type of phone cord is connected to the device

•Checks that the phone cord is plugged into the correct port

•Checks for a dial tone

•Checks for an active phone line

•Tests the status of your phone line connection

The device prints a report with the results of the test. If the test fails, review the report for information on how to fix the problem and rerun the test.

To test fax setup via the device control panel

1.Set up the device for faxing according to your particular home or office setup instructions.

2.Make sure the ink cartridges are installed, and that full-size paper is loaded in the input tray before starting the test.

3.From the device control panel, press Setup.

4.Select Tools, and then select Run Fax Test.

The device displays the status of the test on the display and prints a report.

5.Review the report.

•If the test passes and you are still having problems faxing, check the fax settings listed in the report to verify the settings are correct. A blank or incorrect fax setting can cause problems faxing.

•If the test fails, review the report for more information on how to fix any problems found.

196 Additional fax setup