HP 4500 N manual Configuring TCP/IP Parameters

Configuring TCP/IP Parameters

To configure TCP/IP parameters, you can use the HP JetAdmin software that is included on the printer’s software CD-ROM. If you choose not to use this utility or are using a UNIX system other than HP-UX, Solaris, or SunOS, you can use the printer control panel to configure the following TCP/IP parameters:

●Usage of the BOOTP file for configuration parameters (the default is to use the BOOTP file)

●IP address (4 bytes)

●Subnet mask (4 bytes)

●Default gateway (4 bytes)

●TCP connection timeout (in seconds)

Note	Do not disable BOOTP if you will be using RARP or DHCP to configure
	TCP/IP parameters.

To configure TCP/IP parameters from the printer control panel

1Press MENU until HP EIO 1 MENU displays.

2Press ITEM until CFG NETWORK=NO * displays.

3Press VALUE until CFG NETWORK=YES displays.

4Press SELECT once. CFG NETWORK=YES * displays.

5Press ITEM until CFG TCP/IP=NO * displays.

6Press VALUE once. CFG TCP/IP=YES displays.

7Press SELECT once. CFG TCP/IP=YES * displays.

8Press ITEM to configure TCP/IP parameters manually. BOOTP=YES * displays.

106 Printer Interfaces EN