HP 4500 N manual Dimm Configuration, Do not remove the Dimm in slot #4

Note

CAUTION

Figure A-1

DIMM Configuration

This printer supports up to 208 MB of memory. You can add additional Random Access Memory (RAM) to this printer by installing Dual Inline Memory Modules (DIMMs). The printer uses 100-pin, non- parity, synchronous DRAM memory modules. Extended Data Output (EDO) DIMMs are not supported.

Do not exceed 208 MB of total printer memory.

You can install 4, 8, 16, 32 or 64 MB DIMMs into the printer’s three DIMM slots. Synchronous DRAM modules do not need to be configured in pairs (in corresponding left and right slots).

Do not attempt to remove the DIMM in slot #4 (see figure A-1). The DIMM in slot #4 is part of the printer’s firmware. Removing it will affect printer operation.

Do not remove the DIMM in slot #4.

170 DIMM Installation EN