How To Use Quick Remote

Introducing Quick Remote

Set-Up Requirements for Quick Remote

The following is needed to enable Quick Remote operation:

 

 

 

The central router on which you are going to create the Quick

 

 

 

 

 

 

 

 

 

Remote configuration(s) must already be configured for HP Point-to-

 

 

 

Point routing on the WAN ports that you will use for Quick Remote

 

 

 

access from remote routers. (The Quick Remote configurations that

 

 

 

you create are assigned to these WAN ports on the central router for

 

 

 

downloading to remote routers, but do not affect the configuration

 

 

 

of these ports.)

 

 

 

An active HP Point-to-Point WAN link must exist between a WAN

 

 

 

 

 

 

 

 

 

port on a remote router and a WAN port on a central HP router.

 

 

 

A minimal IP and/or IPX configuration must be stored in Quick

 

 

 

 

 

 

 

 

 

Remote on the central router for the WAN port linked to a WAN port

 

 

 

on the remote router

 

 

 

The remote HP router must be configured to the factory default

 

 

 

 

 

 

 

 

 

prior to power-up or rebooting

 

 

 

N o t e

‘‘Factory default’’ is the state of the router configuration either when the

 

 

router is shipped from the factory or when you use the Clear/Reset

 

 

button combination (described in the installation manual) to clear the

 

 

configuration and reboot the router.

8-4