N o t e :

How To Use Quick Configuration

How To Configure for X.25How To Configure for X.25

The X.25 routing service is available on most HP routers. In the factory default, most of the X.25 parameters are set to default values that may be acceptable for your application. For a minimal X.25 configuration, you will need to enter one of the following sets of values:

DDN

PDN

X.25 Point-to-Point

 

 

(PTOP)*

 

 

 

None

X.121 address of the local

X.121 address of the local

Default settings are provided

port

port

for all values needed for

 

 

minimal configuration

IP address and X.121 address

X.121 address of the remote

 

of each remote port

port

 

 

The connection ID for the

 

 

remote port

 

 

 

*You can specify only one PTOP circuit in Quick Configuration. If you want to specify additional circuits, you must use the Configuration Editor (which you can access from Quick Configuration by using the [/] [M] Hotkey combination).

The Configuration Editor provides appropriate default circuit names and circuit group names.

For descriptions of specific X.25 parameters, refer to the Operator’s

Reference.

3

Configuration

Quick

 

 

3-17