Wrinkled or creased documents | Curled documents |
Torn documents (including those torn | Documents with paper clips or staples |
from spiral notebooks) |
|
Carbon paper | Coated paper |
Extremely thin, translucent paper | Paper with adhesive notes or flags |
| attached |
Photos | Overhead transparencies |
Papers that are stuck together | Paper where the toner has not fully |
| dried, or with wet substances such as |
| glue or correction fluid |
●Smooth out any folds or curls in your documents before placing them into the document input tray. If the leading edge of a document is curled or folded, it may cause a paper jam.
●When loading paper that is smaller than 74 mm (2.9 in) in one dimension (such as business cards), place the pages with the long side parallel to the paper guides.
●To scan fragile documents (such as photos or documents on wrinkled or very lightweight paper), place the document in a clear, heavyweight document sleeve no wider than 216 mm (8.5 in) before loading them into the document input tray.
TIP: If you do not have an appropriately sized document sleeve, consider using a sleeve intended for 
use in a ring binder. Trim the
●Make sure that the hatch on the document feeder is securely latched. To properly close the hatch, press until you hear a click.
●Adjust the paper guides to the width of the documents. Make sure that the paper guides touch the edges of the original. If there is any clearance between the paper guides and the edges of the documents, the scanned image might be skewed.
●When scanning a stack of
●When placing a stack of documents into the document input tray, gently place the stack face down in the input tray with the top of the document pointing downward. Do not drop the stack into the input tray and do not tap the top edge of the stack after you have placed the stack in the input tray.
●Clean the scan rollers if the rollers are visibly dirty or after scanning a document written with or written on with pencil.
10 Chapter 2 Use the scanner | ENWW |
