HP 5GB, 8GB manual Installing Colorado Backup for Windows

Installing the Software 23

Installing Colorado Backup for Windows 95

NOTE: Do not use Colorado Backup for Windows 95 to backup Novell servers.

Colorado Backup for DOS can backup Novell 2.x and 3.x servers or Colorado

Backup for Windows (3.1 or 3.11) can backup Novell 3.x servers.

NOTE: Colorado Backup for Windows 95 can back up computers over your Windows 95 and Windows for Workgroups networks. However, Colorado Backup for Windows 95 will only back up the Windows 95 registry of the computer to which your tape drive is attached. The Windows 95 registry of a remote computer will not be backed up.

1.You will need two formatted, 3.5” (1.44 MB) diskettes labeled “Recovery Disk #1” and “Recovery Disk #2” to use in step 13.

2.Connect the tape drive to your parallel port as described in “Connecting the Hardware” on page 4. The drive must be attached to install and configure the software.

3.Insert the software installation CD into your CD-ROM drive. If your computer does not have a CD-ROM, see page 35.

4.If the first screen does not appear automatically, click the Start button on the Windows 95 task bar, select Run, type D:\SETUP (where D: is your CD-ROM’s drive letter), then click on OK. The following screen appears: