ddr dimms

DDR DIMMs must be 184-pin unbuffered DDR SDRAM (double data rate synchronous dynamic random access memory). The PC ships with one or more memory modules, but you can replace the existing memory module(s) with higher-capacity ones. You can install 64 MB, 128 MB, 256 MB, or 512 MB memory modules in the computer.

installing a memory module

1Turn off the computer and all peripherals.

2Disconnect the modem/telephone cable.

3Disconnect the power cord and all other attached cables (such as the keyboard, mouse, and monitor).

4Remove the side panel and the fan duct (see “removing the side panel” on page 121 and “removing the fan duct” on page 122).

5Locate the memory sockets on the motherboard.

DIMM and

DDR DIMM

NOTE: If all of the memory sockets are filled, you need to remove one of the memory modules (see “removing a memory module” on page 127).

6Move any cabling out of the way, if necessary.

7Push down the two retaining clips on the ends of the memory socket.

8Holding the new memory module by its edges only, remove it from the antistatic packaging. (Avoid touching the memory chips or the gold contacts on the module.) The memory module has one or two small notches on the lower edge that fit into raised bumps in the memory socket.

126user’s guide