Vpp2 tolerance error (12V) = N.NN) Card Vpp2 12V = N.NN (XX)
Vpp2 tolerance error (3.3V) = N.NN) Vpp2 tolerance error (3.3V) = N.NN) Vpp2 tolerance error (5V) = N.NN)
Vpp1 tolerance error (12V) = N.NN)
Address miscompare, access = XXXXXXXX, latched = XXXXXXXX Address miscompare, access = XXXXXXXX, latched = XXXXXXXX Error - Wait bit has no effect
Reset error - stuck high
Card Detect Error
Disk Drives (SCSI HD / internal HD / Floppy)
Internal Diag error: not enough memory for disk buffer.
Failed: no scsi or dock connection.
Error X resetting drive.
Error reading drive parameters.
Failed: no formatted Floppy in drive.
Failed: disk is write protected.
Error: data read does not match data written.
(Note: when the above error occurs, the status window will report the offset where the mismatch occurred and four bytes of expected and actual
data as follows: Data ERROR offset NNN
Error X at track T, head H, sector S.
1.4Mb/813Mb/1.4Gb Ok SeekRetries=N, ReadRetries=N, WriteRetriees=N
The codes reported translate to the following errors:
0x00 successful completion
0x01 invalid function in AH or invalid parameter
0x02 address mark not found
0x03 disk
0x04 sector not found/read error
0x05 reset failed (hard disk)
0x06 disk changed (floppy)
0x07 drive parameter activity failed (hard disk)
0x08 DMA overrun
0x09 data boundary error attempted DMA across 64K boundary or >80h sectors 0x0A bad sector detected (hard disk)
0x0B bad track detected (hard disk) 0x0C unsupported track or invalid media
0x0D invalid number of sectors on format (PS/2 hard disk)
88
