Base I/O address
IrDA port
Mode
Base I/O address
DMA channel
Parallel Port
Mode
Base I/O address
DMA channel
Local Bus IDE Adapter
Floppy disk controller
Security Menu
User Password Is
Supervisor Password Is
Set User Password
Set Supervisor
Password
Password on boot
Power (APM) Menu*
BIOS (specified or automatic).
Sets the I/O address and interrupt.
Sets how the infrared port is configured by the BIOS (specified or automatic).
When IrDA port is enabled, sets the hardware to support SIR (Standard IR) or FIR (Fast IR) infrared communications. (Driver installation is required.)
When IrDA port is enabled, sets the I/O address and interrupt.
When Fast IR mode is enabled, sets the DMA channel.
Sets how the parallel port is configured by the BIOS (specified or automatic).
Sets the port to output only,
Sets the I/O address.
When ECP mode is enabled, sets the DMA channel.
Enables the primary (hard drive) and secondary
Enables the floppy disk drive.
Shows if a user password is set.
Shows if a supervisor password is set.
Press ENTER to set, change, or clear user password. Password length can be no longer than 8 characters,
Press ENTER to set, change, or clear supervisor password. This password protects BIOS Setup settings.
Sets whether a user password is required when the computer boots.
3F8 IRQ4
Disabled
SIR
2F8 IRQ3
DMA 3
Enabled
378IRQ7
DMA 1
Both
Enabled
Default
Clear
Clear
Enabled
Default
PM Control
Power Savings
Standby Timeout
Suspend Timeout
Disables power management, or enables it either always or when on battery power only.
Sets the combination of power management features for your usage. (Choose Customize if you want to set any of the Timeout options.)
Sets the period of inactivity after which the computer goes from On to Standby power mode.
Sets the period of inactivity after which the computer goes from Standby to Suspend
Battery Powered Only or Only When Battery Exists
Maximum Battery Life
2minutes
2minutes
HP OmniBook XE2 | Troubleshooting and Diagnostics |
