n

If the device indicator light did not blink twice, repeat steps 4 and 5, entering either the same code or the next code, if there is one.

!

￿Enter code 9, 9, 9, 9 to reset the selected device to the factory default manufacturer value.

￿Enter code 8, 8, 8, 8 to enter auto setup mode; see “Programming the device code by using auto setup mode” on page 52.

￿Pressing the 1, 3, and 0 buttons on the remote control at the same time resets all programmable devices to factory values.

6Point the remote control at the device, and press the Power button once. The device should turn off. If it does not, repeat steps 4 and 5, trying each code for your brand until you find one that works. If it still does not work, try searching for the code by using auto setup mode; see “Programming the device code by using auto setup mode” on page 52.

n

If the device does not have a Power button, press Play.

7Repeat steps 1 through 6 for each device you want to control with the remote control.

After programming a primary device, you can program a second device for volume mapping; see “Programming the second device for volume mapping” on page 51.

Programming the second device for volume mapping

Volume mapping defines a device in addition to the TV as producing sound. The TV sound (from the primary device) and audio from the second device adjust sound at the same time. Pressing the Volume buttons or the Mute button sends an IR remote control code to adjust the sound level at the second device.

For each device (CBL, DVD, AVR, or AUX) you program to control with the remote control, you can program a second device for volume mapping. When you reprogram the primary device, you must reprogram the volume mapping device.

1Locate the brand of your device and the manufacturer’s codes (see the listings in “Manufacturer’s codes” on page 53).

2Turn on the TV and the primary device (CBL, DVD, AVR, or AUX) for which you want to program a volume mapping device. Turn on the second device.

3Press the Device button on the remote control as needed to select the device (CBL, DVD, AVR, or AUX). Wait until the device indicator light on the remote control goes out.

4Press and hold down the Device button on the remote control for 5 seconds, until the device indicator light blinks, and then release the Device button. The device light blinks one more time and then remains lit, indicating the remote control is in programming mode.

5Press one of the Volume buttons.

6Enter the first four-digit code for your manufacturer from the table. If the code is accepted, the device light blinks twice. If the code is not accepted, the device light blinks three times.

7Point the remote control at the secondary device, and press the Mute button. The sound should mute. If it does not, repeat steps 4 and 5, trying each code for your brand until you find one that works.

Repeat these steps for each primary device (CBL, DVD, AVR, or AUX) you want to program for volume mapping.

Operating the TV

Operating the TV 51