HP DC5100 Accessing DPS Through Computer Setup, DPS, File, Power, Storage, Security, Advanced, Self-Test, 3.Select Storage > DPS Self-Test

Drive Protection System (DPS)

Accessing DPS Through Computer Setup

When the computer does not power on properly you should use Computer Setup to access the DPS program. To access DPS, perform the following steps:

1.Turn on or restart the computer.

2.When the F10 Setup message appears in the lower-right corner of the screen, press the F10 key.

✎If you do not press the F10 key while the message is displayed, you must turn the computer off, then on again, to access the utility.

A choice of five headings appears in the Computer Setup Utilities menu: File, Storage, Security, Power, and Advanced.

3.Select Storage > DPS Self-Test.

The screen will display the list of DPS-capable hard drives that are installed on the computer.

✎If no DPS-capable hard drives are installed, the DPS Self-Testoption will not appear on the screen.

4.Select the hard drive to be tested and follow the screen prompts to complete the testing process.

When the test has been completed, one of three messages will be displayed:

■Test Succeeded. Completion Code 0.

■Test Aborted. Completion Code 1 or 2.

■Test Failed. Drive Replacement Recommended. Completion Code 3 through 14.

If the test failed, the completion code should be recorded and reported to your service provider for help in diagnosing the computer problem.

Troubleshooting Guide www.hp.com C–3