HP IO manual Geometry and capacity information not available. appears

Attach status is Status unknown: Driver is in MINIMAL MODE:

Data Volume Information: If the -doption is used, then the following data volume information is reported in addition to the basic information:

•Physical bytes written

•Physical bytes read

All Information: If the -aoption is used, then all information is printed, which includes the following information in addition to basic and data volume information:

Adapter information:

•Manufacturer number

•Date of manufacture

•Power loss protection status

•PCIe bus voltage (avg, min, max)

•PCIe bus current (avg, max)

•PCIe power limit threshold (watts)

•PCIe slot available power (watts)

•PCIe negotiated link information (lanes and throughput) Block device information:

•Part number

•Manufacturer's code

•Manufacturing date

•Vendor and sub-vendor information

•Size of the device, out of total capacity

•Format status and sector information (if device is attached)

•FPGA ID and Low-level format GUID

•PCIe slot available power

•PCIe negotiated link information

•Card temperature, in degrees Centigrade

•Internal voltage: avg. and max.

•Auxiliary voltage: avg. and max.

•Percentage of good blocks, data and metadata

•Lifetime data volume statistics

Error Mode Information: If the IO Accelerator is in minimal mode, read-only mode, or write-reduced mode when fio-statusis run, the following differences occur in the output:

•

•The reason for the minimal mode state is displayed (such as Firmware is out of date. Update firmware.)

• Geometry and capacity information not available. appears.

•No media health information appears.

Utilities 49